1 female terminal and the male terminal
　　1.1 of the male terminal or the female terminal shall be a copper alloy material, or plated copper alloys, nickel or nickel alloy.
　　Exception: If the structure or electrical appliance allows, female or male terminal board terminals may be plated or non-alloy corrosion-resistant plating but
　　1.2 molded female terminal or have been trimmed in the form of the male terminal if the terminal belt when the terminal strip is continuously working tool into the terminal and the terminal is crimped and with separation, then this case, the terminal and the terminals in contact with the edge of the plating is not required.
　　2 Standard Terminal
　　Section 10 of the mechanical test, test and plug terminal 11 insertion - pull out the standard terminal test material used should be non-plated brass, equivalent to C26000 alloy
　　Standard Terminal 2.2 Section 12 of the temperature and thermal cycling tests used should be corrosion-resistant tinplate or steel, according to Rockwell 30T hardness standard hardness of Rockwell hardness 68 ± 5.
　　Exception: Only if the female terminals connected to a copper alloy male terminal, then when you need to use a standard terminal C26000 copper alloy tested. Standard terminal 2.3 by Rockwell 30T hardness standard, made of brass hardness of 62 ± 7